Fort Wayne Auto Repair

You've just arrived at the store shopping and you're ready to head home.  You put your key in the ignition and… oh, no! The ignition won't turn! What do you do now?

Don't panic.  There are some things you can do to get going again.  The first thing to do is see if you have a locking steering wheel, an anti-theft feature that was introduced around 1970.  Sometimes it sticks.  Move the steering wheel side to side while you try to turn the key and you might be able to get it to release. 

Another thing to check is to see if your vehicle is in gear.  Most vehicles will only allow you to start the ignition if it's in park or neutral.  If you have an automatic transmission vehicle and it is in park, try jiggling the shift lever and try the key again.  Sometimes the safety mechanism doesn't properly make contact or gets a little sloppy. 

If both of these don't work, it could be your vehicle's battery is dead.  Some newer electronic systems require power so the key can turn. Others have alarm systems that detect if doors are open. 

Other issues that can cause key problems include something jammed in the lock cylinder.  Or some of the springs or pins inside may be stuck.  Consider that it may be the key itself.  Sometimes they get bent or simply wear out from the number of times they've been put in and taken out of the cylinder.

No matter what the cause, the first time this happens you should have your repair service facility check it out. That’s because if it happens once, it can happen again.  Even if you were able to get going again on your own, your ignition/key has warned you that something's wrong.  Have it checked out by a pro so you’re not locked into a bad situation.

Ed's Car Care Center
7811 North Clinton Street
Fort Wayne, IN 46825
2604835721
http://www.edscarcarecenter.com

There's nothing like that sinking feeling when you turn the key and nothing happens in your vehicle.  A lot of us are quick to blame the battery.  But it may instead be your alternator that's failing.

Your battery supplies power to start your vehicle, but the alternator is what sends power when your engine is running.  The good news is alternators last a fairly long time, and it's not unusual to get seven years out of one. But they can give up the ghost thanks to the harsh conditions in the engine compartment.

Alternators have bearings inside them that keep things turning smoothly.  Debris, liquid, dirt and more can team up with the high temperatures your engine generates to cause those bearings to seize up.  That's not good, and if that happens, you may even be able to hear the bearings grind.

Other symptoms of a dying alternator are a squealing noise in the engine compartment or your headlights may go dim and bright, dim and bright.  You might even notice an electrical smell.  Any of these signs warrants a trip to your service facility.

Here's something else to think about.  If your alternator's bearings have seized up and the unit's shaft is not turning freely, that can destroy the belt that's attached to it.  So don't be surprised if your service advisor says both parts have to be replaced. 

There are different grades of alternators you can buy, but consider just how important this part is to keep your vehicle running.  Your service advisor will give you options based on your driving style and vehicle.  Remember, if you notice any of those symptoms that may signal a failing alternator, have it taken care of before you wind up stuck somewhere at the side of the road.

Ed's Car Care Center
7811 North Clinton Street
Fort Wayne, IN 46825
2604835721
http://www.edscarcarecenter.com

You expect your heater/air conditioner to work like it should.  You have a control for temperature and one for fan speed.  You even have a control for what vents the air comes out of. 

Don't be surprised one day if your blower fan develops a mind of its own and starts going crazy.  Most of the time, you may find that it starts blowing at full speed, and nothing you do to try to control it does any good.  This is what may be happening.

Your blower motor has an electronic component called a resistor.  It does what its name says; it offers resistance.  When you want the fan to run more slowly, you turn the fan speed down.  That resistor accomplishes that by turning its resistance up.  When the resistor fails, the power has nothing to slow it and the fan speeds up. 

It's a small part and can fail due to age or corrosion.  It's usually not an expensive part, either, but it's often found in a location that's not that easy for the technician to get to.  That means labor costs will vary depending on the design of your vehicle. 

Occasionally, a faulty resistor can cause the blower motor not to work at all or only partially come on.  But other things can cause that as well, such as a faulty fan switch or vent control. 

This is where a technician's training comes in.  Special equipment can track down precisely where the issue is so you can be assured the correct part is being replaced.

It's just not pleasant when the blower motor isn't following orders.  Have your service facility check it out so you can be the blower's boss, like it should be. 

Ed's Car Care Center
7811 North Clinton Street
Fort Wayne, IN 46825
2604835721
http://www.edscarcarecenter.com

Know anyone who doesn't love a power seat in an SUV, a car, truck or van? They're convenient and precise in their adjustments.  But when they break, oh, what a pain.  Not only is it inconvenient, it may leave your seat position too close to the steering wheel or too far from the pedals.  This is a must-fix problem.

There are many things that cause a power seat to fail:

• Seat controls.  These are either at the side of the seat or in the door.  Both are places that can be exposed to moisture or other contaminants.  When the controls stop working, they usually need to be replaced.
• Seat motor.  Electric motors are what make a power seat move, and sometimes they fail.  Sometimes they just get worked to death and die of old age.  Replacement is the most common remedy.
• Fuses. A power seat is, after all, powered by electricity and all vehicle power systems have fuses to protect them.  A technician can determine which fuse may have blown and replace it.  But it's also important to figure out what caused the fuse to blow and deal with that, too.
• Wires.  There are wires under the seats that move when you move the seat.  Sometimes they get stretched, kinked or ripped.  In a power seat malfunction, it may be a wiring harness that needs to be replaced.
• Gears.  They help the seat move and may need to be realigned or replaced.
• Obstructions.  Yes, a piece of trash or a kid's toy has been known to jam up the works of a power seat. Taking them out of the mechanism may get your seat working again.

Most people pay extra to have power seats in a vehicle. So make sure you keep that convenient feature working. And don't forget that it's a safety issue, too.

Ed's Car Care Center
7811 North Clinton Street
Fort Wayne, IN 46825
2604835721
http://www.edscarcarecenter.com